These steps are how to put in a generic standard ceiling lover. If you have a more decorative lover, please consult your installation manual included with the fan.
Step 1.
Turn off the switch and also the breaker to the electrical container.
Step 2.
Remove existing lover or light fixture. Without having an existing fixture with a power box, please contact a great electrician to have one mounted.
Step 3.
Inspect the existing power box to determine if a lover brace box will be necessary to hang the ceiling lover from. Consult an electrical contractor if needed.
Step 4.
Get rid of the ceiling fan from the shipment box and make sure all parts exist.
Step 5.
With the fan engine housing sitting on the floor, put the correct size of down fly fishing rod on the top of the fan. Several ceiling fans will come supplied with 2 . a 5″ and a 6″ down rod or just one particular size. If you need a longer lower rod, please purchase one.
First, 1st remove the ball mounted on the rod by removing the screw located on edge to set up the down rod. Slide the ball to decrease the rod, and it may help pin that is now unwrapped. Remove the ball from the decreased rod. Install the decrease rod to the top edge of the fan. The decrease rod will either twist into place or trip into place. Use the furnished safety bolt to trip through the decrease rod housing and secure it together with the pin on the other side. Tighten all safety screws to the decrease rod.
Step 6.
Slide almost any covers that your fan may offer to hide often the down rod mounting penetration. If your fan does not contain a cover, proceed to step 7.
Step 7.
Slide the Canopy onto the decrease rod and allow it to help fall to the top of the admirer housing.
Step 8.
Maest? Install the ball using sliding it onto the lower rod. Lower it slightly to reveal the holes near the top of the down rod. Put in the pin taken out previously and slide the particular ball back up the fly fishing rod so the pin seats in the ball. Tighten the safety bolt that holds the ball to the fly fishing rod.
Step 9.
At this point, I love to remove the blades and knife arms and affix the particular blades to the blade forearms using the supplied screws; this program installation will be later.
Step 10.
Install the hanging clump onto the electrical box.
Phase 11.
Install the lover motor housing by environment the ball inside the hold of the hanging bracket. Spin the fan so that its seat is designed correctly in the groove.
Move 12.
Wire the upper limit fan to the power. Fans will have several wires this extend from the fan generator. Consult the manual to get proper wiring. Usually, black color is for the motor, pink is for a light kit should you have one, white is essential, and green is ground. Discovering using pull places to eat on the ceiling fan to overpower the light kit and admirer speeds, you will often combine the blue and black from a fan and connect to the capability from the ceiling.
Step 13.
If your ceiling fan comes with remote control, you may have a cover-mounted receiver that must be installed at this point.
Step 14.
Once the fan is effectively wired, ensure all wiring is pushed up inside the electrical box.
Step 15.
Slide the down rod and adhere to the canopy with the anchoring screws.
Step 16.
Put in blades to the motor.
Phase 17.
Install a light system if you have one. Remove the base hub assembly by removing the screws that hold that to the motor. Unclip the particular wiring harness. Once the center is removed, remove the base hole plug. Feed the particular wiring from the light system through the hole in the limit and screw the light system to the hub. Once installed, twine the light kit to the readily available wires within the hub. Show the wire harness together again. Slide the hub back into the motor housing and protect using the screws taken away previously.
Step 18.
Put up any glass that you may have for one light kit.
Enjoy your ceiling fan.
Read also: